Ha habido un problema al cargar los comentarios.

Error Invalid Download Directory

Portal de asistencia  »  Base de datos  »  Artículo en vista


Screenshot:

This error can occur right after starting downloads.

Troubleshooting guide:

  1. Check the download-target
    Make sure that the path used really exists. If your target is e.g. a removable USB drive, make ure it is still plugged in.
    Chances are also that the drives' letter has changed and differs from the one it initially had when you set your download directory in JD.
  2. [Especially Windows users]: Check the filename/path for length and invalid characters
    Some OS have path/filename length limitations and character limitations (especially Windows).
    You can easily check this by choosing a "safe" path like "C:\Users\testUser\Downloads\" and renaming your failing item in JDownloader to a simple and short name.
    If the error disappears, it was most likely due to a too long path and/or forbidden characters within path/filename.
    You can auto-shorten long filenames and the resulting download paths using Packagizer rule(s).
  3. Check long path due to enabled setting "Subfolder by packagename".
    If the name of your added file is very long and it is the only file in your package and you got "Subfolder by packagename" active, that can make your download path very long.
    It can help to disable the mentioned setting. Afterwards, remove- and re-add all links which you were unable to download.
  4. Permission problems
    Inexperienced Linux users are often using invalid paths where JDownloader has no permission to write to or plain wrong paths.
    Synology:
    If you're running JD on Synology hardware, you may have set a path going to your system partition - select a working path as described here.
    Linux via package installation:
    If you're running JD on Linux and have installed it via community package stores Snap or Flatpak you probably ran into a permission issue as both are limiting folder access.
    Check your config accordingly or install JDownloader without a container.
    The following command can be used to allow access to removable media: sudo snap connect jdownloader2:removable-media
    Linux normal:
    Also as a normal Linux user you most likely ran into a permission issue as there are no relevant path length limitations under Linux.
    Make sure that JDownloader has the permissions to write to the assigned download-destination and try again.

 


Artículos relacionados


On-Premise Help Desk Software by SupportPal